VIRANIX stone carpet flooring is supplied as a single-component material: the natural stone aggregate and the binder are pre-mixed at the factory in the bucket.

Before use, there's no need to dose separate components or set mixing ratios.

This reduces the risk of installation errors and ensures consistent quality on every surface.

The system is built on a combination of selected, natural stone aggregate and high-quality binder.

The material structure is flexible, able to follow minor substrate movement while forming a stable, uniform flooring.

It provides a decorative look while working with a technically controlled, predictable layer structure.

With the proper layer structure and topcoat, VIRANIX stone carpet resists UV radiation, rain, and temperature fluctuations.

This allows it to be used both indoors and outdoors, whether on a terrace, stairs, walkway, or driveway.

The flooring's properties depend on the chosen grain size, layer thickness, and topcoat type.

A properly prepared substrate is the foundation of successful installation. The surface must be solid, clean, and free of dust and grease. One of the most important technical requirements is that the substrate's moisture content must not exceed 9%, since excessive moisture hinders the resin's adhesion.

Equally important is the pH value, which must not exceed 10 — this can be a particular issue with fresh concrete, so concrete flooring must be left to cure for at least 28 days before applying stone carpet to it. If the surface is too smooth, it's a good idea to roughen it up (e.g. by sanding) so the resin can adhere properly.

For floor coverings, applying a special resin-based primer layer is strongly recommended. This helps seal the pores, reduces the substrate's absorbency, and strengthens the flooring's adhesion.

For wall coverings, priming is always necessary, and it can improve durability.

For decorative installations, the primer can also help prevent the applied resin from soaking into the wall, resulting in a more attractive, even surface with less material used.

In high-humidity rooms (e.g. bathrooms, kitchens), priming can also contribute to moisture protection and the flooring's long-term stability.

The single-component VIRANIX stone carpet material must be applied to the surface with simple hand tools
(such as a trowel or float).

It's important to apply only one layer. This ensures an attractive appearance and even drying.

A layer that's too thick can stretch as it dries, causing cracks or even delamination. The applied flooring must be left to dry completely, which takes 24–48 hours at +20°C depending on conditions, and only after that can the surface be used to its full extent

VIRANIX PRIMECOAT 1K topcoat is a single-component, ready-to-use coating that requires no mixing.

Its job is to unify the look of the stone carpet surface, improve its cleanability, and provide basic surface protection.

The 1K topcoat is not waterproof, and is not suitable for sustained standing water or heavy mechanical loads. It's used primarily on indoor or covered outdoor surfaces where there's no standing water.

The 2K topcoat is a two-component system that requires mixing at a 20:1 ratio (A:B).

Its job is to seal the stone carpet's pores, increase water resistance, and improve mechanical and chemical resistance.

The 2K topcoat is required for sustained water exposure, outdoor use, and vehicle loads. When applied properly, it significantly increases the flooring's service life and resistance.